![]() The Lenz LI100F is an improved version of the LI100.The Lenz LI100 is Lenz's original computer interface.ZTC Controls ZTC521 (with XpressNet (aka X-Bus V3.0) software)Ĭurrently the following XpressNet computer interfaces are supported by JMRI:.Unknown The following systems are untested, but should be at least partially Paco Canada's RS2PC (adds RS-Bus based Feedback without XpressNet).Paco Canada's GenLI-S88 (adds Feedback to existing XpressNet System).ZTC Controls ZTC511 (with Command Station Software version 4.0).Roco MultiMouse (Roco Part number 10810).Roco LocoMaus 2 (Roco Part number 10760).Lenz LZV200 based systems (software version 3.x).Lenz LZV100 based systems (software version 3.x).Lenz LZ100 based systems (software version 3.x). ![]() Specific limitations are also expressed in the Limitations section The following table tries to show which systems support these three feature groups. Getting Feedback from the layout (the state of turnouts, ops-mode.Programming decoders on a programming track or in ops mode.Operating Locomotives and Turnouts on the layout.In general, the features that JMRI cares about can be grouped into three areas: You can access via JMRI - if the hardware doesn't support it, it isn't there to be used by Unfortunately, this restricts the features "supports all features" to "bare bones minimal". ![]() The XpressNet protocol allows the DCC manufacturers that use it to select whatįunctionality they wish to provide in their command stations. ) specifies the electrical communications standards and command set for devices The XpressNet specification ( available from Roco (some models), Viessmann and ZTC Controls. XpressNet is a Command Bus developed by Lenz and used by: Atlas, Hornby, Lenz, OpenDCC Layout Automation Use JMRI to automate parts of your layout and operations: Tools JMRI tools for working with your layout:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |